Upgraded the double-cutting function on Woodsoft Nesting.

Following suggestions from many users, Woodsoft Nesting will perform two or more passes when one of the following three conditions is met: 1) The ratio of the long edge to the short edge is greater than X times. 2) The workpiece area is smaller than Y mm². 3) The ratio of the workpiece area to the area of the surrounding rectangle is less than Z%. The numbers X, Y, and Z can all be configured on the interface. – Condition 1 controls the double cutting of long bar-shaped parts. – Condition 2 controls the double cutting of small parts. – Condition 3 controls the double cutting of curved, hollow parts, etc. By allowing the configuration of these three parameters, users can customize the double cutting according to the specifics of their machinery. They can even proactively skip double cutting if the machine has good vacuum suction. #woodsoft #woodsoft_nesting #gcode